I created an element link using a field “cost center hierarchy” and I have a drill set up to drill through the hierarchy which in turn, through the element link, will filter my two charts. My drill is turned on. This works fine alone. I go to add a second table for my field “cost element” connected to the same two charts. This second table is not a drill path I just want to pick one of the fields in the list. I’m getting an error when trying to create the second element link saying, “The selection cannot be set in drill mode”. I can add the “cost element” as an input control and it filters okay but I’d rather have it as a field in the report. Is this not possible or am I not setting it up properly?